2008 HONDA CR-V FOG LIGHTS INSTALLATION INSTRUCTIONS

Download PARTS LIST Right fog light Left fog light Fog light harness Fog light switch harness Right trim Left trim Switch Relay Bracket 15Wire ties 4 Wire ties with clip 2 Tapes 8 Self-tapping screws, 5 x 16 mm. Washer bolt, 6 x 16 mm Flange nut, 6 mm Fuse (20A) TOOLS AND SUPPLIES REQUIRED #2 Phillips screwdriver Flat-tip screwdriver Diagonal cutters Ratchet 10 mm Socket 10 mm Combination wrenches Hook tool Isopropyl alcohol Utility knife Masking tape. INSTALLATION 1. Make sure you have the anti-theft codes for the audio and navigation system (if equipped), and write down the XM radio presets (if equipped). 2. Disconnect the negative cable from the battery. 3. Remove the front bulkhead cover (seven clips). 4. Remove the front bumper (four self-tapping screws, six clips, and two bolts). 5. Remove the five clips from the left inner fender, and pull down the left inner fender. 6. To protect the bumper, apply masking tape to the front bumper around the left fog light opening. 7. Using a utility knife, cut out the front bumper as shown. Take care not to damage the front bumper. After cutting, remove any burrs from the edges of the hole. 8. From the outside of the front bumper, install the left trim. 9. Install the left fog light to the front bumper using four self-tapping screws. 10. Repeat steps 6 thru 9 to install the right fog light. Routing the Fog Light Harness 11. Route the fog light harness 1-pin connector in front of the inner fender as shown. Plug the fog light harness 1-pin connector into the vehicle harness 1-pin connector. 12. Secure the fog light harness to the vehicle harness using two wire ties. 13. Remove the vehicle ground bolt. Secure the fog light harness ground terminal to the vehicle ground terminal using the ground bolt you just removed. 14. Secure the fog light harness to the vehicle harness using two wire ties. 15. Route the fog light harness under the left headlight, and secure the fog light harness clip to the vehicle panel. 16. Secure the other two fog light harness clips to the holes in the resonator. 17. Secure the fog light harness to the front bulkhead. With a Vehicle Harness: Secure the fog light harness to the vehicle harness near the harness clips using two wire ties.